|
Part III (47.5.1 – 47.5.7)Date: 2015-10-07; view: 339. GSM C450 NMT TACS Overview of systems Part II (47.4 – 47.4.5)
TACS stands for Total Access Communications System, and was adapted from the AMPS standard by the UK when cellular radio was licensed for operation from 1985. The adaptation was necessary to suit European frequency allocations which were at 900MHz, with 25kHz channel spacing. This meant a reduction in frequency deviation and signalling speed was necessary (BS, 1990). The signalling scheme ofAMPS was retained largely unchanged, but some enhancements were introduced, particularly in the procedures for location registration, to make the standard more suitable for deployment in systems offering contiguous nationwide coverage. The opportunity was also taken to introduce extra features, such as signalling of charge rate information (e.g. for payphones). TACS was originally specified to use the full 1(X)O channels (2 x 25MHz) allocated to mobile services in Europe. However in the UK, only 600 channels (2 x 15MHz) were released by the licensing authority, the remainder being reserved for GSM. Subsequently an additional allocation of channels below the existing TACS channels was made, namely the Extended TACS (ETACS) channels, and the standard was modified accordingly. TACS equipment availability and cost have both benefitted from the standard's similarity to AMPS, and TACS systems have been adopted by several European countries (UK, Eire, Spain, Italy, Austria and Malta), in the middle east (Kuwait, UAE and Bahrain) and the far east (Hong Kong, Singapore, Malaysia and China). In Europe, TACS is on an equal footing with NMT in terms of installed customer base. A variant of TACS (called J-TACS) has also been adopted in Japan. NMT stands for Nordic Mobile Telephone (system), and was developed jointly by the PTTs of Sweden, Norway, Denmark and Finland during the late 1970's/early 1980's.The system was designed to operate in the 450MHz band, and was later adapted to also use the 900MHz band. Although NMT was developed after AMPS, it saw commercial service before it, opening in late 1981. NMT450 uses a channel spacing of 25kHz, speech modulation being analogue FM with a peak frequency deviation of 5kHz, the same as standard PMR practice. NMT900 also uses a frequency deviation of 5kHz, but with a 12.5kHz channel spacing to double the number of available channels, albeit with a degraded adjacent channel rejection performance which must be taken into account during frequency planning. Signalling is at 12(K) bit/s using audio fast frequency shift keying (FFSK). Error protection of the signalling information is by means of a Hagelbarger convolutional forward error correcting code. NMT was designed from the outset to support international roaming and was first implemented with full four nation roaming in the four participating countries (Norway, Sweden, Finland and Denmark). Since then NMT450 has been deployed in many other European countries (Austria, Spain, Netherlands, Belgium, Luxembourg, France, Iceland, Faroe Is., Turkey and Hungary) but due to differences in the frequency allocations in the 450MHz band between countries, not all networks are fully compatible to allow roaming. NMT900 was developed as a necessity as capacity became exhausted on the NMT450 networks, and has been deployed since 1987 as an overlay network in several countries, and in Switzerland as their main network. C450 (also known as Netz-C) was developed by Siemens during the early 1980's under the direction of the (West) German PTT, Deutsche Bundespost. Commercial service opened in 1985 following a trial period. C450 has a channel spacing of 20kHz, in common with other mobile services in Germany at 450MHz and speech modulation is analogue FM with a frequency deviation of 4.0kHz. Signalling for call control is transmitted at 5.28kbit/s by direct FSK. Error protection of the signalling is by bit interleaving with a BCH block code backed by an acknowledgement protocol. In addition, C450 uses continuous signalling between base station and mobile during a call, achieved by time compressing the speech in bursts of 12.5ms, each burst being compressed into 11.4ms. This process opens up slots of 1.1msduration every 12.5ms and the signalling data is inserted into these slots and extracted by the receiver which also time expands the speech back to its original form. This continuous signalling serves several purposes: 1. It allows the base station to send power control and handover messages to the mobile without disturbing the voice channel. 2. The data is checked for jitter, and thereby the quality of the channel can be determined in order to indicate the need for a handover. 3. The time delay between a base station transmitting a data burst and receiving the response from the mobile is measured at the base station and used to calculate the distance between them. 4. The data is used as a timing reference by the mobile to lock its internal clocks. C450 contains a number of advanced features made possible by the application of current developments in technology. Although speech transmission is analogue, it can be regarded as a hybrid technology system, and several of its characteristics such as time slotted signalling channels and continuous signalling during call have been carried through into the GSM system design. Coming later to the European scene, C450 has chiefly only served the German market, although systems are also operating in Portugal and South Africa. The GSM standard was developed as a joint initiative by the members of the Conference of European Posts and Telecommunications administrations (CEPT) with the eventual aim of building a unified pan-European network, giving the user a near uniform service throughout all European countries. An added bonus of a common standard should be lower terminal equipment prices through economies of scale. Work on the standard started in 1982, and by 1987 all the basic architectural features were decided. The full Phase 1 specification was completed in 1990, but work continues on further phases incorporating new features and services. In 1987, the majority of operators participating in GSM signed a Memorandum of Understanding (MoU) committing them to make GSM a reality by installing networks and opening commercial service by 1991. Since that time further operators have signed the MoU, bringing the total to date to 25. The GSM technical standard makes full use of currently available levels of technology, incorporating features such as low bit rate speech, convolutional channel coding with bit interleaving and frequency hopping. The standard is intended to endure for many years to come. Exercise 1 Learn the words and word combinations
Exercise 2 Read the text
Exercise 3 Find the Russian equivalents for the following English words and word combinations
Exercise 4 Answer the following questions:
|